Ideas Of Kite Craft

How to make the Swallow wau wau moon plus the balance of the kang wake frame specially fights Gondi or Wau moon kite is a type of kite that flies aggressively compared to other types of kites but with the note it depends on the level of flexibility both sides of the wing and balance of the frame kite

STEPS TO MAKE A WAIT OF THE MONTH

MATERIALS AND TOOLS

Prepare the main ingredients to make a moon kite such as reed / split bamboo into pieces, yarn to tie the frame, pen or pencil to draw and knife to sharpen.

The length of the size of the bamboo is used according to your pal pal an amount of what kite month you want to make

In this case I made a kite moon with a wingspan of 120 cm and 110 cm spinal column.

and tail section 70 cm

make the wing part

The wing of the moon kite is made up of two parts, the top and the lower part of which the two wings are tied at the ends of each to a pair of wings

First determine the midpoint of the two reeds of the wings that will be sharpened, give the mark / line by using a pencil / pen

Both sides of the wing are traversed from the center titii to the wingtip, the smaller the winged part of the wing. The two sides of the right and left sides of the wing section to obtain the exact same curve as the wing arch image above

Make a 1/2 cut right on the wingtip to unite the top and bottom wings

Try to keep both wing curves not too lithe or too hard, make a moderate curve. It's so young controlled against the wind

Use the yarn to check the wing balance, tie the midpoint of the wing that was in the line with a pencil / pen and Hang the wing tied to the air to see the wing balance

If one side is heavier, tie it at the heavier edges to get the same balance and ensure that the upper and lower wings have the same curvature and weight

pole and spine making

The size of the pole is adjusted to the size of the base of the previously made kite wing

The physical shape of the result on the pole kites, the lower the smaller the diameter of the pole

Once the pole has finished, tie one of the wings of the sharpener at the top of the pole, about 10 cm down from the top of the pole. So the length of the head of the kite is 10 cm

then tie the second wing, right at the bottom of the wing that was tied earlier, with the size 75 cm down from the top of the wing was

Until here can be seen the result of a pair of wings

make a kite tail

Do the tail, in which case you also need to twine the reed and weigh the same as the wings are made, just so that the wings and tail look balanced, the ideal reed length is 1/4 of the kite's wing length. Then try the reed dirunt to thin, because if it is too heavy it will be more heavy burden of the required sound part of the head kites later

Tie the tail right at the bottom end of the pole / spine kites

Next create a tail holder, thin reeds are used tailored to the thin reeds used for the tail that was made earlier

Tie the end of the tail end with the tail end

Tie the other end of the retaining to the pole / spine service. Place the end of the tail end with the tail end

Tie the other end of the retaining to the kite / spine

Regarding the shape of the tail, it is not absolute or depends what kind of shape you want, the most important is the adjustment between the volume of tail weight and the volume of the weight of the sound must be balanced